SLATE SEALER- Enhanced Finish (Sample,1 & 5 litre) Leaves Slate Looking 'Damp'
(Available in Sample, 1 & 5 litre) Long Lifespan, Enriches Natural Colours- Easy to Apply. Impregnating sealer for Slate: Coverage up to: 12 m² per litre
Impregnating Sealer for Slate
Seal and protect Slate tiles and floors
Smartseal Slate Sealer and Natural Stone Sealer is a high quality, clear, solvent free acrylic impregnating coating system. Application of the sealer will alter the chemical structure of the slate or natural stone providing a excellent water repellent and stain resistant surface.
- 1 x 5 litre will treat up to 50m² on average, first coat
- Highly resistant to algae, lichen and staining
- Will leave surface 'damp' or 'wet' looking dependent on porosity of surface
- Average coverage 10 m² per litre first coat and 20 m² per litre second coat, dependent on porosity and finish of surface
- Application by roller or sprayer or suitable cloth
- Touch dry 2-3 hours
- Fully water-resistant in 24 hours
- Lifespan of approx. 5 years can be expected
- Suitable for Limestone can be used externally or internally
PREPARATION: Prior to application of Slate sealer or natural stone sealer ensure surfaces to be sealed are clean, dry and free from contamination. If algae or stains are present pre treat prior to cleaning with a appropriate cleaning product.
**If applied to a surface where a "sweep-in" pointing compound has been used, the natural stone must be fully cleaned with Smartseal Residue Remover prior to sealant application.**
APPLICATION: A suitable pressure sprayer or roller is recommended taking care to avoid any pooling. Application on all substrates should be to full saturation and on vertical surfaces commence at the bottom and work upwards. For internal surfaces application by a suitable cloth is appropriate.
Remove any excess after a maximum of 45 minutes via a dry roller or cloth.
Do not apply in damp conditions nor temperatures below 15°C. Shake container well before use.
All equipment should be cleaned with water immediately after use.
Finish may vary in accordance to type of stone applied to.
Always apply to a test area first.
SHELF LIFE: Store away from direct sunlight and sources of heat. Protect from frost.
12 months (in original sealed container).
Q: I have used the slate colour sealer today. It has now been 3hrs and if i touch it it shows a finger print. How long before I can walk on it
A: If the sealer has not been over applied, you can generally 'tip toe' across it after about 4 hours. The paving would be fully dry after 24 hours. The polymers in the sealer will continue to harden for 7 days. Hope that helps.
Q: Can this sealer be used on a honed granite hearth where a log burner is going to be installed
A: If it is on parts of the hearth not exposed to extreme heat, it would be fine. Samples are available through our website for testing.
Q: Can this be used Inside
A: Yes, the natural stone sealer could be used internally.
Very effective sealer Beware not to apply for several weeks on newly laid slate 4 litres covered 25 sq m easily
Amazing cool enhancer for slate. I followed the recommendation and stunned by the results. It has now been a few weeks and the colour is still the same. Brilliant sealer! I wish I could add photos.
Was expecting it be high gloss for my slate floor in kitchen alas no