Anti-Slip Additive - Mix 1 x 500g to 25L of Sealer (keep stirring regularly)
Use with Solvent Based Sealers (keep stirring reguarly with broom during application). Add to sealer to increase the slip resistance of imprinted concrete surfaces
Anti-Slip Additive for Imprinted Concrete Sealer to make imprinted concrete surfaces less slippery.
Anti-slip additive is added to imprinted concrete sealer to increase the slip resistance of pattern imprinted concrete drives and patios.
Apply direct to sealer drum at a ratio of 1 tub to every 25litre drum, agitate with broom during application. Use of this additive will leave surface of concrete with texture of fine sandpaper, but once dry, the anti-slip additive is invisible to the naked eye.
Use of this product is always strongly recommended to reduce the slippery nature of imprinted concrete driveways and patios.
Only use on final coat of sealer, can be used in greater quantities for extra slippery areas. For further information or application advice please call 01268 722500
Q: I have a small drive. Only big enough for 1 car. We have used before and I think we only used 1 x 5ltr can. I’m ordering 5ltr of Matt sealer. Does the Anti slip come in smaller size as this size is enough for 25ltrs ?
A: The anti slip additive only comes in the 500g size sorry. If you measured out and used 100g of the product, the remainder can be kept for future use.
Q: Q. Once the 500g anti-slip has been added to the 25ltr sealer container is there a shelf life use by date?
A: Once the anti slip additive is added to the sealer, it does not effect the shelf life. If stored correctly, it will last years. Hope that helps.
Q: Hi, I have a 95 m2 drive. How many packs of anti slip would I need. And does it go over impress Crete?. Regard Stephen Rayner
A: 1 x whole Anti-Slip is formulated to be used with a full 1 x 25L drum of Imprinted Concrete Sealer. If you're planning to do 2 coats (always recommended) you would only need one, as two 2 x25L drum would be sufficient to give you two coats. The 1st drum of sealer would be used clear or with colour, which should give you 1 coat. With the 2nd drum, you would add all the anti-slip, which would be enough to give you a 2nd and final coat.
Perfect solution for the new layer of sealant I put down
Sealed my imprinted drive last year with the Smartseal silk sealer product and it was a little slippy . Still had some sealant left over so decided to try the anti slip mixed into it this year and it has been very effective, giving it one more top coat, feels as described now with sandpaper feel. Very impressed with the service and products from Smartseal.
Arrived in 2/3 days not used product waiting for an improvement in the weather.